Hello all ProLinux,

1)Probem1

I am a new to linux and apache. I just setup red hat 9.0 (with apache 2, perl5). After installation the red hat 9.0 (server opition), start apache (/sbin/service httpd start), and view the web browser (localhost). It is working well. Also, I have replace the my edited html page. It it ok. But I do have the problem? I can't view this page over the network (from another PC) - server IP is 192.168.1.103. I do have enble 192.168.103 port 80 (router). I have registered domain name xxxx.com, ISP number 67.xxx.xx.x, and xxxx.com is listed domain servers at zoneedit.com as below:

NS13.ZONEEDIT.COM
NS17.ZONEEDIT.COM

Please help give me the hint how to edit httpd.conf or setup router or anything else make it works.

2) Problme 2
per5 have been install in my system and listed:


/usr/lib/perl5/5.8.0/i386-linux-thread-multi
/usr/lib/perl5/5.8.0
/usr/lib/perl5/site_perl/5.8.0
/usr/lib/perl5/site_perl
/usr/lib/perl5/vendor_perl/5.8.0
/usr/lib/perl5/vendor_perl

my question is how to set the path to my perl on cgi stripts:
I have tried /usr/lib/perl5 or /usr/lib/perl5/5.8.0 both don't work.

when I install webmin, it asked me the perl path, I have tried both two ways above but it told me not correctly.

Please help. Thanks.


Timmy

Please do not post the same thread in more than one forum. Picking the most relevant forum and posting it once there makes it easier for other members to help you and keeps the discussion all in one place.

http://www.linuxquestions.org/rules.php

FUP here: http://www.linuxquestions.org/questi...hreadid=294830