How do I install QLA2100 fc HBA card?
 

i had compile the 2.4.18-3 kernel, but i can't list the scsi disk when run #fdisk -l . The computer halt . What is the reason? The dmesg information as:



SCSI subsystem driver Revision: 1.00
PCI: Found IRQ 9 for device 01:0c.0
PCI: Sharing IRQ 9 with 00:1f.3
qlogicfc0 : Loop Reinitialized
qlogicfc0 : Link is Up
scsi0 : QLogic ISP2100 SCSI on PCI bus 01 device 60 irq 9 base 0xd800
qlogicfc0 : Port Database
wwn: 200000e08b000000 scsi_id: 0 loop_id: 0
wwn: 210000e08b02c679 scsi_id: 1 loop_id: 1
wwn: 50000e1000125062 scsi_id: 2 loop_id: 5
wwn: 50000e100012c8b3 scsi_id: 3 loop_id: 6
wwn: 50000e1000121dfb scsi_id: 4 loop_id: 8
wwn: 50000e100012982f scsi_id: 5 loop_id: 23
qlogicfc0 : scsi abort failure: 4005
qlogicfc0 : abort failed
qlogicfc0 : firmware status is 4000 3
scsi: device set offline - command error recover failed: host 0 channel 0 id 1
un 0
Vendor: HITACHI Model: DKR1C-J072FC Rev: KCC1
Type: Direct-Access ANSI SCSI revision: 02
Vendor: HITACHI Model: DKR1C-J072FC Rev: KCC1
Type: Direct-Access ANSI SCSI revision: 02
Vendor: HITACHI Model: DKR1C-J072FC Rev: KCC1
Type: Direct-Access ANSI SCSI revision: 02
Vendor: HITACHI Model: DKR1C-J072FC Rev: KCC1
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi disk sda at scsi0, channel 0, id 2, lun 0
Attached scsi disk sdb at scsi0, channel 0, id 3, lun 0
Attached scsi disk sdc at scsi0, channel 0, id 4, lun 0
Attached scsi disk sdd at scsi0, channel 0, id 5, lun 0
SCSI device sda: 144410880 512-byte hdwr sectors (73938 MB)
sda:
SCSI device sdb: 144410880 512-byte hdwr sectors (73938 MB)
sdb:
SCSI device sdc: 144410880 512-byte hdwr sectors (73938 MB)
sdc:
SCSI device sdd: 144410880 512-byte hdwr sectors (73938 MB)
sdd: