mandrake 10.1 stall on boot
 

When the boot sequence comes to checking for new hardware phase it stall there ...

I have a AMD DUron 1.8
Usb mouse
PS2 KB

2HD 40 g 160 g
geforce 2 mx


>Added
It seem to work when I remove my usb mouse

Try going in to interactive setup by pressing "i" in verbose mode during boot and then tell it no when it asks you to check for new hardware after that just choose "c" on the next item to continue to boot normaly. After that check hardrake for any specific issue or errors pertaining to your mouse. You might be able to figure out a solution there.

yes yes ... your solution was good ... I already did that ... skip that detection ... However I have no mouse, and whenever I invoke another program using drake (kdrake or something like this) it wont work ... but at least it dont

Anyway .... I've switch to Peanut Linux ... Seem that I've tried all distro and everytime there some new problem .... pfff is there a distro that just work. dot. ?

;) dont have to reply on that ... its a free open desparation call...