It keeps telling me
[root@host]\# modprobe ndiswrapper
[root@host]\# dmesg | grep ndiswrapper
ndiswrapper version 0.10 loaded (preempt=no,smp=no)
ndiswrapper (load_driver:1829): failed to prepare drivers

can you please post the output of following commands?

lspci

lsmod

dmesg | grep ndiswrapper

ndiswrapper -l <-- lower case L

root@darkstar:~# lspci
00:00.0 Host bridge: Intel Corp. 82810 GMCH [Graphics Memory Controller Hub] (rev 03)
00:01.0 VGA compatible controller: Intel Corp. 82810 CGC [Chipset Graphics Controller] (rev 03)
00:1e.0 PCI bridge: Intel Corp. 82801AB PCI Bridge (rev 02)
00:1f.0 ISA bridge: Intel Corp. 82801AB ISA Bridge (LPC) (rev 02)
00:1f.1 IDE interface: Intel Corp. 82801AB IDE (rev 02)
00:1f.2 USB Controller: Intel Corp. 82801AB USB (rev 02)
00:1f.3 SMBus: Intel Corp. 82801AB SMBus (rev 02)
00:1f.5 Multimedia audio controller: Intel Corp. 82801AB AC'97 Audio (rev 02)
01:0b.0 Ethernet controller: Belkin: Unknown device 6001 (rev 20)
root@darkstar:~# lsmod
Module Size Used by Tainted: P
intelpci 14400 0
ac97 20160 0 [intelpci]
uart401 7424 0
soundbase 1633856 0 [intelpci ac97 uart401]
sndshield 13312 0 [intelpci ac97 uart401 soundbase]
ndiswrapper 70520 0
parport_pc 15044 1 (autoclean)
lp 6404 0 (autoclean)
parport 22824 1 (autoclean) [parport_pc lp]
keybdev 1892 0 (unused)
mousedev 4020 1
hid 20804 0 (unused)
usbmouse 1880 0 (unused)
input 3200 0 [keybdev mousedev hid usbmouse]
i810_rng 2528 0 (unused)
uhci 24284 0 (unused)
usbcore 58860 1 [ndiswrapper hid usbmouse uhci]
snd-page-alloc 4712 0
pcmcia_core 39172 0
ntfs 51232 1 (autoclean)
ide-scsi 9392 0
agpgart 45092 0 (unused)

root@darkstar:~# dmesg | grep ndiswrapper
ndiswrapper version 0.10 loaded (preempt=no,smp=no)
ndiswrapper (load_driver:1829): Unable to prepare driver
root@darkstar:~# ndiswrapper -l
Installed ndis drivers:
bel6001 hardware present
root@darkstar:~#

seems like it didn't load the correct driver,
check in the folder /etc/ndiswrapper/bel6001

if there is bel6001.sys, remove it and leave rtl8180.sys file.

then reboot

there was no bel6001.sys in there and rtl8180.sys was there, rebooted either way and it still doesnt work

try uninstall ndiswrapper and reinstall??