xorg.conf option for ATI X1650
I have upgraded my video card to an ATI X1650 dual head card. I am running it with two LCD monitors. I am also using the latest driver from ATI. Here is my problem.....
I can get the dual monitors working where the X11 display covers both monitors and everything works and looks correct. The only problem is that I have no DRI 3D support. Code:
romberg@tiger > fglrxinfo Now my question.... what exactly does the Xinerama option do? I know that the card and driver can do the DRI 3D support, but I would like to get it working where the desktop looks and acts 'normal'. Here is my xorg.conf file Code:
|
No one.......
|
Google. Apparently no-one is using similar set-up so it's up to you to find the solution.
btw, did you read the release notes for your ATI driver? Unless I'm mistaken, I seem to remember that one of the known issues of the latest fglrx drivers is precisely that they can't do DRI on both screens at once. |
are your monitors the same?
All those options in your ServerLayout are not needed. Take a look at mine and yours should look similiar. This will allow DRI on both monitors and all that good stuff. It appears you ran aticonfig for dual head when you actually wanted desktop horizontal. Dual head runs an x session on each monitor i assume you don't want this. Horizontal is actually merged frame buffer but that mergedfb option is actually for the radeon open source driver and so is that Xinerama option. Code:
Section "ServerLayout" |
Code:
Option "Xinerama" "on" So is there any way to merge the two into one display buffer and have full 3D support? Keith |
The ATI driver uses its own Xinerama extention your are using xorgs with that option on. You have xorg using duplicates of your video card. Just try my xorg, but use your mouse,files,modules,keyboard in place of mine. You can add you extention and server flags as well should have no problems. Try it and post your xorg.conf with the new changes.
|
OK, taking your xorg.conf and tweeking it got everything up a running with only one minor problem. I have two monitors; Dell 2407( left ) and 2005 ( right ). The resolutions are fine ( 1920x1200 and 1680x1050 ) with the 2407 working as expected, but the right edge and bottom of the 2005 is way off. I am guessing that X is mapping a virtual resolution of 1920x1200 on the 2005's physical resolution of 1680x1050. Anyone know how to force X use a desktop size of 1680x1050 for the 2005?
Keith |
okay, here this from aticonfig have never used it but sounds like what you are looking for. try this(it will make a backup if doesn't work)
aticonfig --mode2=1680x1050 definition: --mode2=W1xH1,W2XH2,W3xH3,.. Change the modes for the second display. You may specify several resolutions separated by commas. Only valid for clone and big desktop settings. |
All times are GMT -5. The time now is 01:03 PM. |