LinuxQuestions.org - XawTV crashes, IVTV loaded correctly

The PCLinuxOS forum went down just shortly after I was making some headway in getting my Hauppauge WinTV-PVR 350 card to work. First, the firmware wasn't setup correctly but I got that taken care of. Now XawTV crashes during setup while scanning for available channels. The dmesg output for IVTV is:

Code:

ivtv:  ==================== START INIT IVTV ====================

ivtv:  version 0.6.1 (tagged release) loading

ivtv:  Linux version: 2.6.16.27.tex1.lve 586 REGPARM gcc-3.3

ivtv:  In case of problems please include the debug info between

ivtv:  the START INIT IVTV and END INIT IVTV lines, along with

ivtv:  any module options, when mailing the ivtv-users mailinglist.

ivtv0: Autodetected Hauppauge WinTV PVR-350 card (cx23415 based)

ACPI: PCI Interrupt 0000:01:09.0[A] -> Link [APC2] -> GSI 17 (level, high) -> IRQ 19

tuner 3-0061: chip found @ 0xc2 (ivtv i2c driver #0)

tda9887 3-0043: chip found @ 0x86 (ivtv i2c driver #0)

saa7115 3-0021: saa7115 found @ 0x42 (ivtv i2c driver #0)

saa7127 3-0044: saa7129 found @ 0x88 (ivtv i2c driver #0)

msp3400 3-0040: MSP4448G-A2 found @ 0x80 (ivtv i2c driver #0)

msp3400 3-0040: MSP4448G-A2 supports radio, mode is autodetect and autoselect

tveeprom 3-0050: Hauppauge model 48132, rev K268, serial# 9810825

tveeprom 3-0050: tuner model is LG TAPE H001F MK3 (idx 68, type 47)

tveeprom 3-0050: TV standards NTSC(M) (eeprom 0x08)

tveeprom 3-0050: audio processor is MSP4448 (idx 27)

tveeprom 3-0050: decoder processor is SAA7115 (idx 19)

tveeprom 3-0050: has radio, has IR remote

ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)

ivtv0: loaded v4l-cx2341x-dec.fw firmware (262144 bytes)

ivtv0: Encoder revision: 0x02050032

ivtv0: Decoder revision: 0x02020023

ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total)

ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total)

ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total)

ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total)

ivtv0: Create encoder radio stream

ivtv0: Allocate DMA decoder MPEG stream: 16 x 65536 buffers (1024KB total)

ivtv0: Allocate DMA decoder VBI stream: 512 x 2048 buffers (1024KB total)

ivtv0: Create decoder VOUT stream

ivtv0: Allocate DMA decoder YUV stream: 24 x 43200 buffers (1024KB total)

ivtv0: loaded v4l-cx2341x-init.mpg firmware (155648 bytes)

tuner 3-0061: type set to 47 (LG NTSC (TAPE series))

ivtv0: Initialized Hauppauge WinTV PVR-350, card #0

ivtv:  ====================  END INIT IVTV  ====================

:tisk:

This might be helpful as well. When trying to run TVTime, I get the following message:

Code:

Running tvtime 1.0.2.

Reading configuration from /etc/tvtime/tvtime.xml

I/O warning : failed to load external entity "/home/cylon/.tvtime/tvtime.xml"

videoinput: Card failed to allocate capture buffers: Invalid argument