IVTV PVR 150 No Audio
Hi,
I'm using FC3 with 2.6.12-1_1381 Kernel and PVR 150 card with IVTV 0.4.6 Driver.
I'm getting only video and no audio. pls help me in this,
modprobe.conf
------------------------
alias eth0 8139too
alias scsi_hostadapter ata_piix
alias snd-card-0 snd-intel8x0
options snd-card-0 index=0
install snd-intel8x0 /sbin/modprobe --ignore-install snd-intel8x0 && /usr/sbin/alsactl restore >/dev/null 2>&1 || :
remove snd-intel8x0 { /usr/sbin/alsactl store >/dev/null 2>&1 || : ; }; /sbin/modprobe -r --ignore-remove snd-intel8x0
alias usb-controller ehci-hcd
alias usb-controller1 uhci-hcd
alias char-major-81 ivtv
--------------------------
ivtv: ==================== START INIT IVTV ====================
ivtv: version 0.4.6 (tagged release) loading
ivtv: Linux version: 2.6.12-1.1381_FC3 686 REGPARM 4KSTACKS gcc-3.4
ivtv: In case of problems please include the debug info between
ivtv: the START INIT IVTV and END INIT IVTV lines, along with
ivtv: any module options, when mailing the ivtv-users mailinglist.
ivtv0: Autodetected WinTV PVR 250 card (cx23416 based)
ACPI: PCI Interrupt 0000:01:04.0[A] -> Link [LNKC] -> GSI 10 (level, low) -> IRQ 10
ivtv0: Unreasonably low latency timer, setting to 64 (was 32)
ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50]
tveeprom: Hauppauge: model = 26139, rev = G1A5, serial# = 9533907
tveeprom: tuner = <unknown> (idx = 105, type = -1069826176)
tveeprom: tuner fmt = PAL(D/K) (eeprom = 0x74, v4l2 = 0x00400e17)
tveeprom: audio_processor = MSP3400C (type = 4)
ivtv0: Corrected autodetection from WinTV PVR 250 to WinTV PVR 150
ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61]
tuner 1-0061: chip found @ 0xc2 (ivtv i2c driver #0)
cx25840 1-0044: ivtv driver
cx25840 1-0044: cx25842-23 found @ 0x88 (ivtv i2c driver #0)
cx25840 1-0044: loaded v4l-cx25840.fw firmware (16382 bytes)
ivtv0: i2c attach to card #0 ok [client=cx25840, addr=44]
wm8775 1-001b: ivtv driver
wm8775 1-001b: chip found @ 0x36 (ivtv i2c driver #0)
ivtv0: i2c attach to card #0 ok [client=wm8775, addr=1b]
tda9885/6/7: chip found @ 0x86
ivtv0: i2c attach to card #0 ok [client=tda9887, addr=43]
ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
ivtv0: Encoder revision: 0x02050032
ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total)
ivtv0: Allocate DMA encoder YUV stream: 161 x 12960 buffers (2048KB total)
ivtv0: Allocate DMA encoder VBI stream: 80 x 26208 buffers (2048KB total)
ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total)
ivtv0: Create encoder radio stream
tuner 1-0061: tuner type not set
ivtv0: Initialized WinTV PVR 150, card #0
ivtv: ==================== END INIT IVTV ====================
------------------------------------------------------
Thanx in Advance
Jagadish
|