Cannot get into Interactive Mode on RHEL-Itanium
 

All,

HW: Itanium
SW: RH Enterprise

I don't seem to be able to go into 'interactive Mode' (by pressing the I-button) when the system starts it's daemons. I DO see the prompt, but don't seem to get enough time to enter the I, after which the system simply carries on...

Marc Thoelen
Universiteit Hasselt
Belgium

Try again, the timing is a little hard to get. Nothing wrong with pressing the 'i' key a number of times (5-6) quickly. Usually if you press the 'i' key a number of times during the first two or three daemon loads (the first green [OK] lines) you will get into the interactive mode.