LinuxQuestions.org - SuSE 9.3

I need help on setting up a Software Raid. I am a Newbie to Raid but not Linux.
(I am the founder of the Alaska Linux Users Group)

This is what I have:

2 - 80 Gig Hard Drives.
And I want to be able to create a softraid RAID1,

I have followed the Howto's as follows: (Using YAST2)

/dev/hda---------------------------------------- /dev/hdc
====================================
20 Gigs /dev/hda1 /------------------20 Gigs /dev/hdc1
4 Gigs /dev/hda2 /boot---------------4 Gigs /dev/hdc2
20 Gigs /dev/hda3 /var/--------------20 Gigs /dev/hdc3
1 Gig /dev/hda4 SWAP---------------1 Gig /dev/hdc4 SWAP

This setup is covered on page 28 of Software-RAID-HOWTO

Converting a non-RAID REDHAT System to run on Software Raid.
Even though I am using SuSE.

Now when I use YAST2 to create soft Raid there really isn't much documentation
in the YAST2 Manual. Ok during the initial installation, I go to expert partition Mgr.
create the above. Using EXT3, as the RAID create instruction indicate. Then I click on the
RAID option and click on create RAID this is on the first Drive hda, it indicates that I must have 2 partitions of 0xfd. Now when you create a software RAID to you create the RAID on both drives or just 1. Like if I change all of the partitions of hdc to 0xfd. Now if I did that which drive would be the mirrored drive. I am setting up a DNS server that I have installed soft RAID several times on and I have still not been able to get it to work properly. Probably because I have never set one up.