Hi all,
I just installed Debian Etch on a Pentium II. During startup, i suppose after loading USB drivers, i get bombared with the following error messages:
hub 1-0:1.0: over-current change on port 1
hub 1-0:1.0: over-current change on port 2
the system still boots into the GUI, and is quite usable from there, but i cant use any other tty as they get flooded with the above messages.
Does anyone know how to disable USB? or a more sophisticated solution?
there is no entry in fstab, but listed in mtab nontheless.
Cheers

to disable USB add these lines:


blacklist uhci_hcd
blacklist ohci_hcd
blacklist ehci_hcd

to:

/etc/modprobe.d/blacklist

That didnt work though, still get flooded with error message:
hub 1-0:1.0: over-current change on port 1
hub 1-0:1.0: over-current change on port 2
dmesg also only shows the above

lspci:

00:00.0 Host bridge: Intel Corporation 430TX - 82439TX MTXC (rev 01)
00:07.0 ISA bridge: Intel Corporation 82371AB/EB/MB PIIX4 ISA (rev 01)
00:07.1 IDE interface: Intel Corporation 82371AB/EB/MB PIIX4 IDE (rev 01)
00:07.2 USB Controller: Intel Corporation 82371AB/EB/MB PIIX4 USB (rev 01)
00:07.3 Bridge: Intel Corporation 82371AB/EB/MB PIIX4 ACPI (rev 01)
00:11.0 VGA compatible controller: S3 Inc. ViRGE/DX or /GX (rev 01)
00:13.0 Ethernet controller: Digital Equipment Corporation DECchip 21041 [Tulip Pass 3] (rev 11)
00:14.0 Multimedia audio controller: Ensoniq ES1371 [AudioPCI-97] (rev 07)

lsusb:
Bus 001 Device 001: ID 0000:0000