LinuxQuestions.org - how to check on system devices currently using what module(driver)?

- Linux - Newbie (https://www.linuxquestions.org/questions/linux-newbie-8/)

- - how to check on system devices currently using what module(driver)? (https://www.linuxquestions.org/questions/linux-newbie-8/how-to-check-on-system-devices-currently-using-what-module-driver-667441/)

how to check on system devices currently using what module(driver)?

Hi, i using command: lsmod to show all current loaded modules include video driver, sound card...the eth0(this is in VMware) i know the module using pcnet32, why i using command lsmod than have show module pcnet32 but dont have show eth0, lets said if i don't know my eth0 is using pcnet32(module) than how to check it?

How to check current devices using which module?like eth1 using ipw2100(this is intel wifi card)?

Thank you.

I don't know about on Red Hat, but on Slackware-12.1 "lspci -v" as root.

Code:

for example:

root@silas:~# lspci -v

<snip>

00:08.0 Bridge: nVidia Corporation MCP55 Ethernet (rev a3)

        Subsystem: ASUSTeK Computer Inc. Unknown device 8239

        Flags: bus master, 66MHz, fast devsel, latency 0, IRQ 23

        Memory at fe02a000 (32-bit, non-prefetchable) [size=4K]

        I/O ports at b000 [size=8]

        Memory at fe029000 (32-bit, non-prefetchable) [size=256]

        Memory at fe028000 (32-bit, non-prefetchable) [size=16]

        Capabilities: [44] Power Management version 2

        Capabilities: [70] MSI-X: Enable- Mask- TabSize=8

        Capabilities: [50] Message Signalled Interrupts: Mask+ 64bit+ Queue=0/3 Enable-

        Capabilities: [6c] HyperTransport: MSI Mapping Enable- Fixed+

        Kernel driver in use: forcedeth

My version of lspci is version 2.2.10.