Hi
I have RHEL4 with kernel-2.6. I have a USB to serial convertor FT232R.this cable is sending data to a device used for temperature sensing.it is working well in windows.i have to make its interface and working in linux with kernel-2.6.RHEL4 already have pl2303.c and pl2303.h files in /usr/src..../drivers/usb/serial/pl2303.c so i did the step
1...modprobe pl2303
2...lsmod shows the loaded module and dmesg also confirms it.now i have to make an interface from where i give value that passed to usb port and then shows the output on screen.in RHEL there is a software "QT Designer" but i donot know how to use it and the display. Can some one tell me
**i installed the module in correct way..is there a need to apply commands make, make install...etc.
waiting 4 reply...
thanks in advance

This is a 2nd duplicate of
http://www.linuxquestions.org/questi...driver-644201/
which is in a more appropriate forum, and
http://www.linuxquestions.org/questi...verter-644191/
which has already been reported for closure.

Mods: Please close this one, too.

LQ'ers: Post your answers there.
(http://www.linuxquestions.org/questi...driver-644201/)

OP: Shame on you, you really should know better.
N.B., if I were feeling mean, I would post a similar msg. there just to bump you off the 0-reply lists & lower your exposure.

Reporting.

Please post your thread in only one forum. Posting a single thread in the most relevant forum will make it easier for members to help you and will keep the discussion in one place. This thread is being closed because it is a duplicate.


http://www.linuxquestions.org/questi...verter-644191/