-   Linux - Newbie (
-   -   help for installing driver pl2303, USB to serial converter (

Misbah Naveed 05-22-2008 10:59 PM

help for installing driver pl2303, USB to serial converter
I have RHEL4 with kernel-2.6. I have a USB to serial convertor FT232R.this cable is sending data to a device used for temperature is working well in windows.i have to make its interface and working in linux with kernel-2.6.RHEL4 already have pl2303.c and pl2303.h files in /usr/src..../drivers/usb/serial/pl2303.c so i did the step
1...modprobe pl2303
2...lsmod shows the loaded module and dmesg also confirms i have to make an interface from where i give value that passed to usb port and then shows the output on RHEL there is a software "QT Designer" but i donot know how to use it and the display. Can some one tell me
**i installed the module in correct there a need to apply commands make, make install...etc.
waiting 4 reply...
thanks in advance

archtoad6 05-23-2008 05:29 AM

This is a duplicate of
which is in a more appropriate forum.

Mods: Please close this one.

LQ'ers: Post your answers there.

OP: Shame on you, you should know better.
N.B., if I were feeling mean, I would post a similar msg. there just to bump you off the 0-reply lists & lower your exposure.


Tinkster 07-13-2008 01:36 PM

Please post your thread in only one forum. Posting a single thread in the most relevant forum will make it easier for members to help you and will keep the discussion in one place. This thread is being closed because it is a duplicate.

Closing the original because the dupe is placed more sensibly.

And thanks for the notification - but I'd still appreciate if you
left moderation to the mods.

All times are GMT -5. The time now is 07:59 PM.