Hi,first time using mandrake (8.0) and first time installing.I'm trying to get a data collector called cflowd running.I've managed do get all the requirments and now i did a configure and a make.The make ran for about 10min and now is stuck.The hard disk is working hard but i don't know if it actually takes a lot of time or if it's stuck.I'm running a pentium 3 with 128ram.Does any know what's happening.The terminal shell is at the same point for the last 2 hours!!!is there a way to see if the make is giong on and just needing all this time?Something is happening because the whloe system is very slow.
tks to all

up anyone?

First, please don't bump a thread after just 27 minutes. The rules ask that you don't bump a thread until 24 hours have passed. This allows for users in all time zones to see threads.

The best way to bump a thread is to supply extra information, in this case, were there any errors at the end of your ./configure? Check the last 20 or 30 lines produced. This will normally say what it's looking for that isn't there.