Configure Scanner in Ubuntu
 

Hello All,

I'm having trouble configuring a scanner. I have an Epson Workforce 500 (MFP). I can print fine but Ubuntu does not recognize the scanner. I've tried installing "pipslite1.4.0" from http://www.avasys.jp/lx-bin2/linux_e/spc/DL1.do. Also i was required to load libltdl3 in order for the pipslite install package to work. However I'm having no luck. Is it possible to use this scanner in linux? Any suggestions are appreciated.


Thanks,

Here is a good place to get you started. Looks like it should work. http://www.linuxprinting.org/show_pr...-WorkForce_500 also for the scanning you might try and application called xsane http://www.xsane.org/xsane-introduction.html

Thanks for the reply. Actually i have installed the print driver, and printing works great for this printer. I also have xSane Image Scanning Software v 0.996. However when launched, i receive the message "No devices available".

Additional info:

When I run $ sane-find-scanner from the terminal I receive the following results:

found USB scanner (vendor=0x04b8, product=0x084c) at libusb:001:004
found USB scanner (vendor=0x0483, product=0x2016) at libusb:002:004

can you run xsane are super-user? This will bring up xsane with your device.

check if you are part of scanner group.

If you are not, add yourself to the group. I've hardly used ubuntu so I may be wrong but usually not being in the group could cause the message you got.

Acutally I think you are correct on that. Or he may need to add himself to the wheel group.

When I get a chance I will install xsane on my laptop and do some testing.

I added my user to the scanner group, but no luck, and when I run sudo xsane from the terminal, I receive a stern warning... then same message; "no devices available".

hi
Even I am having similar problem with configuring my scanner Epson CX5500, I am able to print, but says no 'no devices available' when I try sudo xsane.
aarav