Redhat 7.2 and a Linksys LNE100TX configuration question...

Dayewalker · 11-18-2001, 12:26 PM

I've been running Redhat 7.2 for about a week now and I've read through lots of different help sites and how-to's and the like that describe how to setup a Linksys LNE100TX, but even after downloading the Tulip driver and going through the steps that the sites have listed, I'm still unable to get it working. Anyone else have any experience with Redhat 7.2 and this network card?

Zvezda · 11-19-2001, 10:08 PM

I have this same NIC installed since redhat7.0 just did a complete format and reinstall of 7.2 last week and RedHat 7.2 has these drivers preinstalled for the Linksys 100TX no drivers were needed
possible hardware conflict in the stystem bios is causing the card to become un-reconized with Kudza (i think that is the name off the plug & play software)
anyway check for IRQ conlicts move the card to another slot make sure you setup eth0-in the netconfig

Dayewalker · 11-20-2001, 03:15 PM

Ok thanks for the info! I think that it's recognizing it, but I may just be stupid and not know how to configure it and get it setup...which is most likely the case...