| itroot |
10-24-2007 01:42 PM |
NetworkManager: internet at boot.
So I have PPPoE internet connection (LAN ethernet). My Linux is opensuse 10.3. This connection is working as dsl device, and i configured it using YaST. There are some options in YaST such as device activation. When I choose devise activation "at boot" or "at hotplug" nothing happens at boot.
So, the question is: how to make NetworkManager connect to internet at boot time, not manually?
Code:
:~> /sbin/route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.130.1 * 255.255.255.255 UH 0 0 0 dsl0
10.1.24.0 * 255.255.252.0 U 0 0 0 eth0
172.16.0.0 gw-7.1.fds 255.240.0.0 UG 0 0 0 eth0
SECTOR-V-v.ru-L gw-7.1.fds 255.0.0.0 UG 0 0 0 eth0
loopback * 255.0.0.0 U 0 0 0 lo
default * 0.0.0.0 U 0 0 0 dsl0
Code:
:~> /sbin/ifconfig
dsl0 Link encap:Point-to-Point Protocol
inet addr:194.88.211.200 P-t-P:192.168.130.1 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1492 Metric:1
RX packets:23725 errors:0 dropped:0 overruns:0 frame:0
TX packets:27869 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:11464582 (10.9 Mb) TX bytes:29173287 (27.8 Mb)
eth0 Link encap:Ethernet HWaddr 00:17:31:E3:99:D9
inet addr:10.1.24.65 Bcast:10.1.27.255 Mask:255.255.252.0
inet6 addr: fe80::217:31ff:fee3:99d9/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:128169 errors:0 dropped:0 overruns:0 frame:0
TX packets:176287 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:20143783 (19.2 Mb) TX bytes:244453193 (233.1 Mb)
Interrupt:16 Base address:0x6000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:434 errors:0 dropped:0 overruns:0 frame:0
TX packets:434 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:26456 (25.8 Kb) TX bytes:26456 (25.8 Kb)
|
