LinuxQuestions.org

LinuxQuestions.org (/questions/)
-   Linux - Networking (https://www.linuxquestions.org/questions/linux-networking-3/)
-   -   Fedora Boot Problem (https://www.linuxquestions.org/questions/linux-networking-3/fedora-boot-problem-144534/)

landholl 02-10-2004 02:42 PM

Fedora Boot Problem
 
I have a desktop with two hard drives. I have Win 2000 on the local disk, and have installed Fedora COre 1 on the slave drive, using the GRUB boot loader at startup to choose between the two. I originally had an ethernet card installed tha was used with wIN 2000 that is connected directly to my cable modem. I installed Fedora and during setup Eth0 was detected, and I chose to auto detect DHCP. Once installation was complete, I rebooted, and during startup the computer stalls while "Starting Network". This stall requires a reboot I have let it sit for hours with no change. I tried installing a new NIC card and reinstalling Fedora, and get the same problem. When I take out the NIC card and install Fedora the system boots fine. I really am new at this, and trying to get through this frustration. Any help will be greatly appreciated.

david_ross 02-10-2004 02:55 PM

Welcome to LQ.

Perhaps you could give us some more information such as what type of network card you have.

benjithegreat98 02-10-2004 02:58 PM

It sounds like your nic is not configured in linux. When you boot up have you noticed the part that says press I to go to interactive mode? You can do that and when it gets to the part about the network, just say no. Getting in interactive mode can be tough. It'll probably take several attempts. After you get intoyour system you should start to work to get you network card configured properly. If you get it configured properly and reboot, you shouldn't have any trouble.

landholl 02-10-2004 03:21 PM

Thanks benjithegreat98
 
Any suggestions on configuring the nic card once in Linux I have linux drivers but am lost as to how to install them or configure the card?

benjithegreat98 02-10-2004 03:36 PM

Do you know what type it is? You can at least go to the point where you configure you network. It is one of the options in the "start menu". Start there and see if you can see anything wrong. You can stop and start it from there too.

landholl 02-10-2004 03:52 PM

benjithegreat98
 
If it makes a difference it is a D-Link card and is supposed to be compatible with Linux, I appreciate your help, I am on my way home in a few to try your suggestions I will keep my fingers crossed!


All times are GMT -5. The time now is 12:33 AM.