ethtool support for changing NIC parameters
desprately need the ethtool support and i am loking for all options of ethtool for changing NIC parameters
interface parameters is ‘ethtool -C eth0 adaptive-rx off
adaptive-tx off rx-usecs 20 rx-frames 5 tx-usecs 60 tx-
The Linux command to improvement in the processing of UDP traffic from the
do this is “ethtool -G eth0 rx 511 rx-jumbo 255 tx 511’. tuning, at all message rates.
to be precise ineed all upper changes to tune my nic.
but the ethtool options not working properly.
[root@ddit-cgl Desktop]# ethtool -c eth0
Coalesce parameters for eth0:
Cannot get device coalesce settings: Operation not supported
[root@ddit-cgl Desktop]# ethtool -g eth0
Ring parameters for eth0:
Cannot get device ring settings: Operation not supported
[root@ddit-cgl Desktop]# ethtool -G eth0
Cannot get device ring settings: Operation not supported
plz reply soon. thanks
|