Can't get two kingston NICs to work

hubabuba · 12-11-2004, 12:25 PM

Hi All!

I recompiled kernel 2.4.26 on slack 10 with support (builin support no as a module) for RealTek 8139too because during the boot both eth0 and eth1 are detected with RealTek 8139B chipset. But then, later during the boot, messages say:

Note: /etc/modules.conf is more recent then /lib/modules.2.4.26/modules.dep
modprobe: Can't locate module 8139too

ifconfig command only shows the lo and eth settings.

did anyone have the same problem?

thanks

Peacedog · 12-11-2004, 05:36 PM

Hi, I've not encountered this problem, both of my nics work fine. Just the same this may help.

http://www.ibiblio.org/pub/Linux/doc...WTO.html#ss2.4

good luck.