Any one know how to configure BSNL ADSL modem
 

Hi Everyone!
I am using Mandrakelinux10.1. I want to connect internet via BSNL ADSL modem. But i am not successful. There is too many settings of gateway, vci vpi, WAN and other all.
The modem is UTSTARCOM UT-300R2
Anyone know these settings.
Thanx

try using these commands

adsl-setup
adsl-start
adsl-stop
adsl-status

Thanx ilnli!

Actually i already tried these commands and also the link comes to connected but when i goes to browsing the browser shows me error like there is no connection well i give you the shell output after successful connection.
..connected

the output of adsl-status is:

adsl-status: Link is up and running on interface ppp0
ppp0 Link encap:Point-to-Point Protocol
inet addr:59.94.105.204 P-t-P:59.94.105.1 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1492 Metric:1
RX packets:49 errors:0 dropped:0 overruns:0 frame:0
TX packets:7 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:3962 (3.8 Kb) TX bytes:244 (244.0 b)

I also tried all the ways to connect from mandrake control center to rp-pppoe.

Need BSNL ADSL Modem - will pay Rs. 5000 as rent for one Month
 

We have a BNSL Internet connection in Bangalore, India but the stupid BSNL doesn't have a modem.

We need a BSNL modem urgently for one month and we are ready to pay Rs. 5000 as rent to you and also we will pay your BSNL bill for that month, so you make Rs. 5000. Also, if you have want to use the internet, we will provide that also free.

The BSNL modems are UTSTARCOM UT-300R2 or huawei SMARTAX MT800 but there could be others.

Please call 98457 94207 if you are interested ASAP.

Thank you