| HankScorpio |
11-10-2011 12:14 PM |
Problems starting the wireless network card in monitor mode, dell inspiron n4110
I have problems starting the wireless network card in monitor mode, dell inspiron laptop n4110.
I'm buy a usb wireless network card D-Link DWA-125, this card use the Ralink RT3070 chipset, i'm have installed Backtrack 5 distribution, and I could not fully execute some scripts. (airmon-ng related)
This is the output of some commands that I executed:
Code:
root@bt:~# ifconfig -a
eth0 Link encap:Ethernet HWaddr xx:xx:xx:xx:xx:xx
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:41 Base address:0x2000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:149 errors:0 dropped:0 overruns:0 frame:0
TX packets:149 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:10433 (10.4 KB) TX bytes:10433 (10.4 KB)
wlan0 Link encap:Ethernet HWaddr xx:xx:xx:xx:xx:xx
inet addr:192.168.0.3 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: xxxx::xxxx:xxxx:xxxx:xxxx/xx Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:16856 errors:0 dropped:0 overruns:0 frame:0
TX packets:11146 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:15418809 (15.4 MB) TX bytes:1627686 (1.6 MB)
wlan1 Link encap:Ethernet HWaddr xx:xx:xx:xx:xx:xx
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
root@bt:~# iwlist wlan1 scan
wlan1 Scan completed :
Cell 01 - Address: xx:xx:xx:xx:xx:xx
Channel:2
Frequency:2.417 GHz (Channel 2)
Quality=70/70 Signal level=-39 dBm
Encryption key:on
ESSID:"Hack-Lab"
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 6 Mb/s; 9 Mb/s
11 Mb/s; 12 Mb/s; 18 Mb/s
Bit Rates:24 Mb/s; 36 Mb/s; 48 Mb/s; 54 Mb/s
Mode:Master
Extra:tsf=00000001b5d24f4a
Extra: Last beacon: 820ms ago
IE: Unknown: 00084861636B2D4C6162
IE: Unknown: 010882848B0C12961824
IE: Unknown: 030102
IE: Unknown: 0706555320010B1B
IE: Unknown: 200100
IE: IEEE 802.11i/WPA2 Version 1
Group Cipher : TKIP
Pairwise Ciphers (2) : CCMP TKIP
Authentication Suites (1) : PSK
IE: WPA Version 1
Group Cipher : TKIP
Pairwise Ciphers (2) : CCMP TKIP
Authentication Suites (1) : PSK
IE: Unknown: 2A0100
IE: Unknown: 32043048606C
IE: Unknown: DD180050F2020101020003A4000027A4000042435E0062322F00
IE: Unknown: DD0900037F01010020FF7F
Cell 02 - Address: xx:xx:xx:xx:xx:xx
Channel:1
Frequency:2.412 GHz (Channel 1)
Quality=21/70 Signal level=-89 dBm
Encryption key:on
ESSID:"Allison"
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 9 Mb/s
18 Mb/s; 36 Mb/s; 54 Mb/s
Bit Rates:6 Mb/s; 12 Mb/s; 24 Mb/s; 48 Mb/s
Mode:Master
Extra:tsf=00000073f494c9b3
Extra: Last beacon: 1130ms ago
IE: Unknown: 0007416C6C69736F6E
IE: Unknown: 010882848B961224486C
IE: Unknown: 030101
IE: Unknown: 32040C183060
IE: Unknown: 0706444520010D10
IE: Unknown: 050400010000
IE: Unknown: 2A0104
IE: WPA Version 1
Group Cipher : TKIP
Pairwise Ciphers (2) : TKIP CCMP
Authentication Suites (1) : PSK
IE: IEEE 802.11i/WPA2 Version 1
Group Cipher : TKIP
Pairwise Ciphers (2) : TKIP CCMP
Authentication Suites (1) : PSK
IE: Unknown: DD07000C4300000000
root@bt:~# lshw -C network
*-network
description: Wireless interface
product: Centrino Wireless-N 1030
vendor: Intel Corporation
physical id: 0
bus info: pci@0000:01:00.0
logical name: wlan0
version: 34
serial: xx:xx:xx:xx:xx:xx
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress bus_master cap_list ethernet physical wireless
configuration: broadcast=yes driver=iwlagn driverversion=2.6.39.4 firmware=17.168.5.1 build 33993 ip=192.168.0.3 latency=0 link=yes multicast=yes wireless=IEEE 802.11bgn
resources: irq:48 memory:d1600000-d1601fff
*-network
description: Ethernet interface
product: RTL8101E/RTL8102E PCI Express Fast Ethernet controller
vendor: Realtek Semiconductor Co., Ltd.
physical id: 0
bus info: pci@0000:03:00.0
logical name: eth0
version: 05
serial: xx:xx:xx:xx:xx:xx
size: 10MB/s
capacity: 100MB/s
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress msix vpd bus_master cap_list ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=r8169 driverversion=2.3LK-NAPI duplex=half latency=0 link=no multicast=yes port=MII speed=10MB/s
resources: irq:41 ioport:3000(size=256) memory:d0404000-d0404fff memory:d0400000-d0403fff
*-network
description: Wireless interface
physical id: 2
bus info: usb@2:1.3
logical name: wlan1
serial: xx:xx:xx:xx:xx:xx
capabilities: ethernet physical wireless
configuration: broadcast=yes driver=rt2800usb driverversion=2.6.39.4 firmware=0.29 link=no multicast=yes wireless=IEEE 802.11bgn
root@bt:~# lsusb
Bus 004 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub
Bus 003 Device 003: ID 0458:003a KYE Systems Corp. (Mouse Systems) NetScroll+ Mini Traveler / Genius NetScroll 120
Bus 003 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 002 Device 004: ID 07d1:3c16 D-Link System DWA-125 Wireless N 150 Adapter(rev.A2) [Ralink RT3070]
Bus 002 Device 003: ID 8086:0189 Intel Corp.
Bus 002 Device 002: ID 8087:0024 Intel Corp. Integrated Rate Matching Hub
Bus 002 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 001 Device 004: ID 1bcf:2881 Sunplus Innovation Technology Inc.
Bus 001 Device 002: ID 8087:0024 Intel Corp. Integrated Rate Matching Hub
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
root@bt:~# lsmod | grep rt
rt2800usb 12228 0
rt2800lib 40789 1 rt2800usb
crc_ccitt 1581 1 rt2800lib
rt2x00usb 10496 1 rt2800usb
rt2x00lib 37138 3 rt2800usb,rt2800lib,rt2x00usb
mac80211 277511 4 rt2800lib,rt2x00usb,rt2x00lib,iwlagn
parport 34080 1 lp
cfg80211 165732 3 rt2x00lib,iwlagn,mac80211
root@bt:~# modinfo rt2800usb
filename: /lib/modules/2.6.39.4/kernel/drivers/net/wireless/rt2x00/rt2800usb.ko
license: GPL
firmware: rt2870.bin
description: Ralink RT2800 USB Wireless LAN driver.
version: 2.3.0
author: http://rt2x00.serialmonkey.com
srcversion: 1BF0335B5467644CC4BAF13
alias: usb:v0586p341Ad*dc*dsc*dp*ic*isc*ip*
.
.
.
alias: usb:v07B8p2870d*dc*dsc*dp*ic*isc*ip*
depends: rt2x00lib,rt2800lib,rt2x00usb
vermagic: 2.6.39.4 SMP mod_unload
parm: nohwcrypt:Disable hardware encryption. (bool)
root@bt:~# dmesg | grep rt2800
[ 1080.970941] Registered led device: rt2800usb-phy1::radio
[ 1080.970976] Registered led device: rt2800usb-phy1::assoc
[ 1080.971005] Registered led device: rt2800usb-phy1::quality
[ 1080.971229] usbcore: registered new interface driver rt2800usb
The problems:
Code:
root@bt:~# airmon-ng
Interface Chipset Driver
-> And the script does not stop and do nothing
^C // Finish the process manually
root@bt:~# airmon-ng start wlan1
Found 5 processes that could cause trouble.
If airodump-ng, aireplay-ng or airtun-ng stops working after
a short period of time, you may want to kill (some of) them!
PID Name
1229 dhclient3
1230 dhclient3
1747 wpa_supplicant
1762 dhclient
3568 dhclient
Process with PID 1229 (dhclient3) is running on interface wlan0
Process with PID 1747 (wpa_supplicant) is running on interface wlan0
Process with PID 3568 (dhclient) is running on interface wlan1
Interface Chipset Driver
-> And the script does not stop and do nothing
^C // Finish the process manually
Disconnect the USB network card and try to use the wireless network card in the laptop does nothing to change the situation and the scripts are still not working.
Please help and thanks in advance. |
