Terratec 6Fire and Groovy DeadRat
 

Hey all, straight to the point, Ive come to a dead end, Ive recently just installed linux redhat 9.

Im not a total newbie to linux, (though i dont know too much) ive dabbled with the likes of mandrake and redhat before, also my fav distro, slackware, however i chose redhat this time, because im on a very new PC, and i would suspect i would run into a lot of trouble with hardware support and slackware.

Anyway (god im drivling) All's going well......However!!

I am using a TerraTec DMX 6 Fire sound card, nice peice of kit. especially for my music production....Yet Redhat fails to detect it....And i dont even begin to know what i could try regarding 'modprobe xxdriver'

So, basically has anyone got any ideas...?

Anyone been here with this sound card? or had some experience with it?

i run lspci -vv and i get this::;
------------------------------------------

03:01.0 Multimedia audio controller: IC Ensemble Inc ICE1712 [Envy24] (rev 02)
Subsystem: TERRATEC Electronic GmbH: Unknown device 1138
Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 32
Interrupt: pin A routed to IRQ 21
Region 0: I/O ports at 5000 [size=32]
Region 1: I/O ports at 5400 [size=16]
Region 2: I/O ports at 5800 [size=16]
Region 3: I/O ports at 5c00 [size=64]
Capabilities: [80] Power Management version 1
Flags: PMEClk- DSI- D1- D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-

---------------------------------------------------

If anyone could shed some light on this i'd be most gratfull. As im dieing to give audio editing a whirll...

Many many thanks

_Mhz