Hi,

I changed my motherboard to an Asus, all is working fine, (all configured with kudzu) also the nic (SMC gigabit PCI), but the speed is slower than before. (max 10mB/s) measured in Windows with Du Meter..

Also, ethtool eth2 command says no data to show..

I have FC3, cpu 2.8 ghz and a Promise ATA/133 PCI controller., I use Cat5e utp cable.

dmesg says:


eth2: -- ERROR --
Class: Hardware failure
Nr: 0x270
Msg: 2 Pair Downshift detected

eth2: network connection up using port A
speed: 100
autonegotiation: yes
duplex mode: full
flowctrl: symmetric
irq moderation: disabled
scatter-gather: enabled

#dhclient eth2
Internet Systems Consortium DHCP Client V3.0.1
Copyright 2004 Internet Systems Consortium.
All rights reserved.


sit0: unknown hardware address type 776
sit0: unknown hardware address type 776
Listening on LPF/eth2/00:04:e2:d0:98:13
Sending on LPF/eth2/00:04:e2:d0:98:13
Sending on Socket/fallback
DHCPREQUEST on eth2 to 255.255.255.255 port 67
DHCPACK from 10.0.0.138
SIOCADDRT: File exists
bound to 10.0.0.153 -- renewal in 2958 seconds.