I am trying to set up a faxserver using Hylafax. I originally got the system with two Digicom PCI Modems which didn't work well since they both reported on IRQ 11. Now I have one external U.S. Robotics, SUSE 10.0 sees it, Hylafax sees it and all is good with it. The second modem is now an LT Winmodem, SUSE sees it and assigns the port ttyLT0 to it. Hylafax does not like this. I would like to set this modem to port ttyS1. Can anyone help?
Thanks
Sal

Did you install the Suse Hylafax software?

http://www.novell.com/products/linux...l/hylafax.html

If yes then did you read the HOWTO and other documentation that comes with the Hylafax software package on Suse? There is a remarkable amount of documentation with this package. Then if that fails to render a solution there is Google.

/srv/www/htdocs/hylafax/HOWTO.html
/srv/www/htdocs/hylafax/Majordomo/help.html
/srv/www/htdocs/hylafax/Modems/index.html
/srv/www/htdocs/hylafax/documentation.html
/srv/www/htdocs/hylafax/modems.html
/srv/www/htdocs/hylafax/setup-advanced.html
/srv/www/htdocs/hylafax/setup-client.html
/srv/www/htdocs/hylafax/setup.html
/srv/www/htdocs/hylafax/source.html
/srv/www/htdocs/hylafax/troubleshooting.html
/usr/share/doc/packages/hylafax/README
/usr/share/doc/packages/hylafax/README.SuSE
/usr/share/doc/packages/hylafax/TODO
/usr/share/doc/packages/hylafax/html
/usr/share/doc/packages/hylafax/html/HOWTO.html
/usr/share/doc/packages/hylafax/html/Modems/index.html
/usr/share/doc/packages/hylafax/html/documentation.html
/usr/share/doc/packages/hylafax/html/modems.html
/usr/share/doc/packages/hylafax/html/operation.html
/usr/share/doc/packages/hylafax/html/overview.html
/usr/share/doc/packages/hylafax/html/setup-advanced.html
/usr/share/doc/packages/hylafax/html/setup-client.html
/usr/share/doc/packages/hylafax/html/setup.html

The problem is not Hylafax it is winmodems and linux. I have another client that had a couple of external serial USR modems, they work just fine. Now I am trying to figure out a problem with the WHFC client software. I am getting a Scheduler NAK'd request error.