Scanner Problem
Having looked all over the web for a solution to my problems I found a site with a download claiming to be the backend for sane I needed to run my scanner.
The machine is a HP Scanjet 3300C. I am using KDE 3.1 I am running Slack 9.1. Linux Kernel 2.4.22 Machine - Dell Dimension 8100 2x USB Ports on the rear. I have downloaded the files I think nessecary, configured and installed them. I run xsane and it looks for the hardware but does not find it. I have summarised my dmesg o/p here for you to look at --- usb.c - registered new driver usbdevfs usb.c - registered new driver hub uhci.c - USB Universal host controller Interface Driver V1.1 uhci.c - USB UHCI at I/O 0xef80, IRQ 10 usb.c - new USB Bus Registered, assigned bus number 1 hub.c - USB Hub found hub.c - 2 ports detected hub.c - new USB device 00:1f.2-2 assigned address 2 then it has another line USB device 2 (vend/prod 0x3f0/0x2o5) not claimed by active driver. then it follows - - - - - - - usb.c - registering new driver - usbscanner scanner.c - usbscanner device (0x3f0/0x2o5) now at scanner0 scanner.c - 0.4.13:USB Scanner Following this message through in my head I see the usb system being initialized and assigned its I/O address, IRQ etc. There are two ports on the rear of the machine this is correct. I am assuming the line mentioning the USB Device 2 is not claimed by an active device as a temporary statement. The last three lines --- assign a scanner to scanner0 - this sounds ok scanner.c - 0.4.13:USB Scanner - not sure what this is; I am assuming this is the HP Specific Driver which has been associated with scanner0. This is the part I cannot work out. Is my problem most likely to be that xsane isnt looking in scanner0, somewhere else perhaps? maybe there are some other commands I can fire at the machine to check the driver status or the USB Hub. Thanks for your help. Rob :) |
hi!
what are the respective results of 'sane-find-scanner' and 'scanimage -L'? |
You also might want to install Gimp and see if you can scan into that.
rberry88 |
All times are GMT -5. The time now is 05:18 PM. |