ATI doesn't make things easy.
After you install the RPM from the website you have to hand edit your /etc/X11/XF86Config file to use the "fglrx" driver instead of the stock Xfree86 "ati" driver. The easiest way to do this will be the following:
Get the normal GUI working with the vesa driver so you'll have that working, now, also backup your existing /etc/X11/XF86Config file somewhere.
Now, its time to get out of X-windows so we can configure it:
init 3
log in as root.
X -configure
That'll create a test file called: /root/XF86Config.new
Edit the .new file and change "ati" under driver in the card section to read "fglrx". To edit it, I'm a big fan of pico, it acts a lot like an archaic word processor, most of the commands are on the bottom of the terminal. Then run the test:
X -xf86config /root/XF86Config.new
To get out of the test (if it succeeds), ctrl+alt+backspace.
If it fails, well, post up the log: /var/log/XFree86.o.log and/or edit in your monitor settings into that test file and try again.
Cheers,
Finegan
|