pentax optio S camera problems
OK, I have this pentax.
First off I plug it in, turn it on. Digikam fails to auto-detect Reading around on similar threads I try As root "modprobe usb_storage" Can't locate module usb_storage I also try modprobe usb-storage This gives no message at all. I am using SuSe 9.0 The last part of dmesg gives me the following. Initializing USB Mass Storage driver... usb.c: registered new driver usb-storage scsi1 : SCSI emulation for USB Mass Storage devices Vendor: Pentax Model: Optio S Rev: 1000 Type: Direct-Access ANSI SCSI revision: 02 WARNING: USB Mass Storage data integrity not assured USB Mass Storage device found at 2 USB Mass Storage support registered. Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0 usb-uhci.c: interrupt, status 3, frame# 1244 usb-uhci.c: interrupt, status 3, frame# 1840 usb-uhci.c: interrupt, status 3, frame# 1458 usb.c: USB disconnect on device 00:10.2-1 address 2 hub.c: USB device not accepting new address (error=-19) hub.c: new USB device 00:10.2-1, assigned address 3 WARNING: USB Mass Storage data integrity not assured USB Mass Storage device found at 3 usb-storage: host_reset() requested but not implemented scsi: device set offline - command error recover failed: host 1 channel 0 id 0 lun 0 usb-uhci.c: interrupt, status 3, frame# 712 usb-uhci.c: interrupt, status 3, frame# 330 usb.c: USB disconnect on device 00:10.2-1 address 3 hub.c: USB device not accepting new address (error=-19) usb-storage: host_reset() requested but not implemented sda : READ CAPACITY failed. sda : status = 1, message = 00, host = 0, driver = 08 Info fld=0xa00 (nonstd), Current sd00:00: sense key Not Ready sda : block size assumed to be 512 bytes, disk size 1GB. sda: I/O error: dev 08:00, sector 0 I/O error: dev 08:00, sector 0 I/O error: dev 08:00, sector 2097144 I/O error: dev 08:00, sector 2097144 I/O error: dev 08:00, sector 0 I/O error: dev 08:00, sector 0 unable to read partition table So it sees a pentax there. Also, if I boot with the camera plugged in, the machine freezes. (Or indeed go into YaST with the camera plugged in.) You can probably see I am fairly clueless, and no techie. So can anyone spell out exactly what I need to do? |
I find an answer here
http://blogs.cocoondev.org/michaelm/...es/001759.html But this raises another question which I shall post later |
All times are GMT -5. The time now is 12:51 AM. |