mount issues pleaseeee help
ok here is my issue.. i have installed 2 - 200 gig HDs.
i did the fdisk /dev/hde and hdg on them they r on a raid card. the system see's them when i do a dmesg.. they r there..
but when i do a reboot it will not mount them . hde is set up i think right way .. hdg isnt set up yet till i figure out hde issues..
i get a message on boot .. fs type worng or bad super blocks or to many fs mounted.. iam useing RH9 i think kernel 2.4
here is the fdisk -l and fstab
**************** fdisk -l ****************
Disk /dev/hdg: 203.9 GB, 203928109056 bytes
255 heads, 63 sectors/track, 24792 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Disk /dev/hdg doesn't contain a valid partition table
Disk /dev/hde: 203.9 GB, 203928109056 bytes
255 heads, 63 sectors/track, 24792 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System
/dev/hde1 1 24792 199141708+ 83 Linux
Disk /dev/hda: 4321 MB, 4321787904 bytes
255 heads, 63 sectors/track, 525 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System
/dev/hda1 * 1 13 104391 83 Linux
/dev/hda2 14 460 3590527+ 83 Linux
/dev/hda3 461 525 522112+ 82 Linux swap
**********************************************
****************** fstab ********************
LABEL=/ / ext3 defaults 1 1
LABEL=/boot /boot ext3 defaults 1 2
none /dev/pts devpts gid=5,mode=620 0 0
none /proc proc defaults 0 0
none /dev/shm tmpfs defaults 0 0
/dev/hda3 swap swap defaults 0 0
/dev/hde1 /mnt/200A ext3 defualts 1 2
/dev/cdrom /mnt/cdrom udf,iso9660 noauto,owner,kudzu,ro 0 0
/dev/fd0 /mnt/floppy auto noauto,owner,kudzu 0 0
***********************************************
i have done both /mnt/200A and /200A still not work ...
under HDE1 and or HDE .. iam at a lose please any help or ideas would be great ty
Last edited by xpftp; 09-27-2006 at 11:16 PM.
|