M$ Strategic Commander access LEDs

NightShroud · 09-13-2007, 12:52 PM

hi there...
I'm writing on a joystick programming software, at the moment to program the pc-dash2 and strategic commander.
And my question is how it is possible to access the leds on the M$ Strategic Commander to show which buttons where programmed and which not?

Links and so to tutorials at usb protocol analyzing or an solution to this problem would be nice...

regards

NightShroud

Peacedog · 09-13-2007, 07:11 PM

Hi NightShroud, Welcome to lq. I can't help with the programming but, you may find some of what you need here.

http://www.lrr.in.tum.de/Par/arch/usb/usbdoc/

Hope that gets you going in the right direction.
Good luck. ;-)

NightShroud · 09-14-2007, 01:14 PM

thanks for the reply...
i took a short look on it and it seems to be very interesting, in any way...
i could clear some question to the data of the usb protocol analyzer i found...
so thanks a lot...

i'll take a closer look in a few days, after finished the programm and maybe a gui for it...

regards

NightShroud