Linuxant errors at boot if card is not inserted - unable to use ethernet cable
 

A couple of days ago I could access the Internet through an ethernet cable. I downloaded the driverloader at http://www.linuxant.com (ndiswrapper doesn't support the TrueMobile 1300 card) and ran it with my Windows driver. After running ifconfig to get the second ethernet device up and running, I was (and am) able to access wireless networks. However, I have run into two problems:

1. If the wireless card is not inserted at bootup, I get an (apparently) unlimited stream of error messages saying that driverloader was unable to start. I don't want to have to always boot up my laptop with the wireless card inserted.

2. I can no longer access the Internet via ethernet cable. If I type:

ifconfig eth0 down
ifconfig eth1 up

I have no Internet access.

Is there a way to configure driverloader and my ethernet cards so that I can manually select the one I want to use after boot?

Thanks,

Brian

ifconfig -a:

eth0 Link encap:Ethernet HWaddr 00:10:C6:38:B8:96
inet addr:192.168.0.4 Bcast:192.168.0.255 Mask:255.255.255.0
UP BROADCAST NOTRAILERS RUNNING MULTICAST MTU:1500 Metric:1
RX packets:532 errors:0 dropped:0 overruns:0 frame:0
TX packets:596 errors:1 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:206071 (201.2 Kb) TX bytes:86049 (84.0 Kb)

eth1 Link encap:Ethernet HWaddr 00:0F:1F:A9:55:99
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:9 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:1999 (1.9 Kb) TX bytes:0 (0.0 b)
Interrupt:4 Base address:0x1800

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:198 errors:0 dropped:0 overruns:0 frame:0
TX packets:198 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:10284 (10.0 Kb) TX bytes:10284 (10.0 Kb)

System Freezes
 

OK - even worse. My system is beginning to freeze periodically. I have four lights at the top of my keyboard: a processing light, a caps lock light, a scroll lock light (I think), and a numlock light. Periodically (twice in the last three hours), my computer freezes completely (doesn't respond to control-alt-delete, control-alt-#, control-c, escape, etc.) and the caps lock and numlock keys beginning blinking. I have to use the power button to reboot. What's going on???

Thanks,

Brian