LinuxQuestions.org
Help answer threads with 0 replies.
Go Back   LinuxQuestions.org > Forums > Linux Forums > Linux - Hardware
User Name
Password
Linux - Hardware This forum is for Hardware issues.
Having trouble installing a piece of hardware? Want to know if that peripheral is compatible with Linux?

Notices


Reply
  Search this Thread
Old 06-29-2004, 12:57 PM   #1
bluebox
Member
 
Registered: Jun 2004
Posts: 71

Rep: Reputation: 9
Linux/WinXP Dualboot and Raid


Hi everybody,

I'm not sure whether this is the right board for my question - depending on the answer, it is either "hardware" or "software" or even "Microsoft".

As the topic states, I'm dualbooting with WinXP Pro and Linux (Suse9.1 Pro so far). Both OSes reside on a legacy IDE-harddisk attached to my Asus P4P800-Deluxe mainboard. This works flawless.

I have two additional harddisks attached to the onboard IDE Raid Controller of the P4P800 Deluxe. What I want to do is run these two harddisks in Raid1-mode with one partition for Linux an one partition for XP.

Using the Raid Controller to do this does not work, as there are no working Linux drivers to do Raid with the Via-Raid-Chip.

So I tried to use the Raid controller as regular IDE controller, put two partitions on each of the two disks and tried to use two partitons with Linux Multi Disk as Software Raid 1 and two partitons with WinXP "dynamic volumes" as Software Raid 1. This does not work either, as Linux MD does not recognise Windows Dynamic Volumes and Windows kills the Linux MD partitons when converting the harddisks to "dynamic".

So, is there a way to either teach Linux to handle "Microsoft dynamic Volumes" or to do a Software Raid with WindowsXP on legacy partitions? Or even any other way to do what I want?

tnx in advance,

bluebox
 
Old 06-29-2004, 03:08 PM   #2
flysideways
Member
 
Registered: Jul 2003
Posts: 151

Rep: Reputation: 30
Have you seen this http://www.viaarena.com/?PageID=297#raid ? The Asus website shows your mb as having a Via 6410 raid controller. If you can use the raid driver for each os and format they array in a format to which you can read and write from either os you should be in business. Suprisingly, Asus does not have a linux driver listed at their download page. Via has binaries and source, it looks like. They at least have instructions on compiling the driver. Maybe I should rethink my previous dislike of Via.
 
Old 06-29-2004, 04:03 PM   #3
bluebox
Member
 
Registered: Jun 2004
Posts: 71

Original Poster
Rep: Reputation: 9
Yes, you're right - the Raid controller is a Via VT6410,
but, no, the Via driver is not compilable. It's a ready compiled binary module with a source code wrapper and it's not usable for Kernel 2.6 and unstable for Kernel 2.4 (I tested it). Via will not give away neither their sourcecode nor a specification of the VT6410. There is a kernel patch of unknown origin that makes it possible to use the VT6410 as ordinary IDE controller, though.

This situation lasts since about one year, so there it no hope of a change. See this thread for further information:
http://forums.viaarena.com/messagevi...E=&STARTPAGE=1

As the Windows driver is not very stable either, I'm away from using the controller as hardware raid controller. I'm looking for a solution without Via made drivers.

Keep your dislike of Via - there are plenty of reasons for it. I supposed, there would be Asus support, but there is none.

Last edited by bluebox; 06-29-2004 at 04:05 PM.
 
Old 06-30-2004, 11:49 PM   #4
flysideways
Member
 
Registered: Jul 2003
Posts: 151

Rep: Reputation: 30
bluebox,

Bummer. I looked at your link. Doesn't look good. I did notice that someone mentioned getting a Promise Fastrack card for the raid. I've never used one as a raid controller in Linux though so I can't speak to its compatability. I have temporarily used one in ide mode until I got an ide card, also Promise. The Fasttrack TX2000 worked fine in FC2 in ide only mode, but I didn't need it as the install was only FC1 (no dual boot) and was a software raid.

My bad Via experience was an Asus a7v133 rev 1.04. I was only using windows on it when I first got it and the chipset drivers were so bad that it even corrupted floppies at about an 85% rate. Many 4in1 and bios updates later all was well but it sure was painfull getting there. I never was able to get any help from Asus' tech support. I don't know if they provide any better help today. Ironically, it now lives on as a FC1 raid 5 headless file server.
 
  


Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off



Similar Threads
Thread Thread Starter Forum Replies Last Post
winXP / linux dualboot via GRUB problems r0bman Linux - Software 4 07-20-2004 03:14 PM
WinXP, Linux, how to dualboot if adding Win2003. letdoit Linux - Newbie 2 05-08-2004 06:42 AM
dualboot for winxp and linux but diff hard drive lafarga Linux - Newbie 3 05-06-2004 05:30 AM
Dualboot with Linux, Win2k Server and WinXP?? eXor Linux - Distributions 3 01-22-2003 05:31 AM
DualBoot Win2k Linux /w Raid via Lilo tvjames Linux - General 0 01-04-2002 06:40 AM

LinuxQuestions.org > Forums > Linux Forums > Linux - Hardware

All times are GMT -5. The time now is 11:44 PM.

Main Menu
Advertisement
My LQ
Write for LQ
LinuxQuestions.org is looking for people interested in writing Editorials, Articles, Reviews, and more. If you'd like to contribute content, let us know.
Main Menu
Syndicate
RSS1  Latest Threads
RSS1  LQ News
Twitter: @linuxquestions
Facebook: linuxquestions Google+: linuxquestions
Open Source Consulting | Domain Registration