I can only connect to the usb1 drives built into the board (when I connect to usb2 I get "waiting for device to settle" then disconnected). Dmesg output is
Quote:
usb 1-2: new full speed USB device using uhci_hcd and address 3
usb 1-2: not running at top speed; connect to a high speed hub
usb 1-2: configuration #1 chosen from 1 choice
scsi5288 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 3
usb-storage: waiting for device to settle before scanning
Vendor: Apple Model: iPod Rev: 1.62
Type: Direct-Access ANSI SCSI revision: 00
usb-storage: device scan complete
|
If I get gtkpod problems later due to usb1 I'll treat that as a separate issue- for now, I can't see my ipod mounted anywhere, ie in /media or /mnt. cat /proc/partitions shows only my hd partitions.
How do I mount this device please?