LinuxQuestions.org

LinuxQuestions.org (/questions/)
-   Linux - Hardware (https://www.linuxquestions.org/questions/linux-hardware-18/)
-   -   FastTrax 100 TX2 and kernel 2.6.7 - don't work (https://www.linuxquestions.org/questions/linux-hardware-18/fasttrax-100-tx2-and-kernel-2-6-7-dont-work-212217/)

Linoge 08-01-2004 02:48 PM

FastTrax 100 TX2 and kernel 2.6.7 - don't work
 
Good day to all!
I have a problem with FastTrak 100 TX2 RAID. My system is Gentoo, kernel 2.6.7. Kernel was build with all IDE, RAID support, ATA RAID, all Promise controllers etc., all this static - no modules. During boot i have message that driver PDC20270 load but no disks connected for controller (but i have 2 disk in array on it!!!). I have drivers (source code) from Promise for this controller but it's work ONLY with kernel 2.4.x and no new! I connected disks in a free mode (not in array) but problem was the same - after boot no one drive were found on this controller.
Please help:
What should I do to make work this controller with 2.6.7?

Linoge 08-03-2004 10:41 AM

Hey! I can't belive that only I have problem with this FastTrak!
Please help!!!


All times are GMT -5. The time now is 11:56 PM.