All I wanted was an extra harddrive :'(

OK, thanks to other posts, I have downloaded the TX2000 from the Promise website (partial source version). I have built it, and copied the FastTrak.o to the modules tree just as the not so clear instructions tell you.

I have appended the lilo.conf with the 'ide1=blah ..etc' with the correct values.

During boot I get the error message "Unresolved symbols in lib/blah/FastTrak.o", anybody know why?

After boot I can insmod and mount the drive, but it should run a lot smoother than this. Anybody had a similar problem?

Thanks

Fixed it

I think I will write a how-to on this issue. Any ideas on where to post it?