Errors with network cards on boot Fedora 11
 

When I boot up Fedora 11 I get the following message:
eth0: link down
ADDRCONF(NETDEV_UP):eth0:link is not ready
ADDRCONF(NETDEV_UP):eth1:link is not ready
ADDRCONF(NETDEV_UP):wlan0:link is not ready

The connections eth0 & eth1 aren't connection via patch cable because I'm not using them. As for wlan0 I need to use it but it connects fine after entering into the GUI.

This is the first time I seen this issue so any help would be helpful.

Sounds like your network connection is being managed by NetworkManager instead of the old method of turning it on at boot.

Forrest

I also have a similar question,
My network card doesn't seem to work with Linux
Runs fine with windows tho, but whenever I install Linux on it
I get an error. the OS sees the card, but it isn't able to give
it an address whenever i give it a static one, it doesn't work either

it says
irq 11 : nobody cared {try booting with the "irq polling" option}
irq 10 : nobody cared {try booting with the "irq polling" option}
irq 10 : nobody cared {try booting with the "irq polling" option}
irq 10 : nobody cared {try booting with the "irq polling" option}
irq 10 : nobody cared {try booting with the "irq polling" option}

Does anybody have a take on this. . .?