Latest LQ Deal: Linux Power User Bundle
Go Back > Forums > Linux Forums > Linux - Hardware
User Name
Linux - Hardware This forum is for Hardware issues.
Having trouble installing a piece of hardware? Want to know if that peripheral is compatible with Linux?


  Search this Thread
Old 09-25-2007, 03:57 AM   #1
LQ Newbie
Registered: Dec 2006
Location: Somwhere
Distribution: Ubuntu Linux 8.10 Intrepid Ibex
Posts: 15

Rep: Reputation: 0
DWL-G122 Ubuntu Feisty wont connect, shows up on scan

Using Ubuntu Feisty, Kernel 2.6.20-15-generic and a DWL-G122 H/W Ver. C1 wireless adapter, I have the adapter recognized and set up using native drivers (not sure which), and an iwlist scan shows up the base station. Iīve downed the interface before setting the essid (putting it back up again after of course), everything looks as though itīs connected, except that when I ping the router I get an error. I just pinged it then and thought 'Yes! it worked!' then I realised that it was going through eth0.

abrenecki@ubuntu-L30:~$ sudo iwconfig
lo        no wireless extensions.

eth0      no wireless extensions.

wmaster0  IEEE 802.11g  Frequency:2.437 GHz  
          RTS thr:off   Fragment thr=2346 B   
wlan0     IEEE 802.11g  ESSID:"SpeedTouch0F9E34"  
          Mode:Managed  Frequency:2.437 GHz  Access Point: 00:10:C6:28:39:57   
          RTS thr:off   Fragment thr=2346 B   
          Encryption key:off
          Link Quality:0  Signal level:0  Noise level:0
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

abrenecki@ubuntu-L30:~$ sudo iwlist wlan0 scan
wlan0     Scan completed :
          Cell 01 - Address: 00:10:C6:28:39:57
                    Frequency:2.437 GHz
                    Signal level=-141 dBm  Noise level=-160 dBm
                    Encryption key:off

abrenecki@ubuntu-L30:~$ ping -c 5 -I wlan0
PING ( from wlan0: 56(84) bytes of data.
From icmp_seq=1 Destination Host Unreachable
From icmp_seq=2 Destination Host Unreachable
From icmp_seq=3 Destination Host Unreachable
From icmp_seq=4 Destination Host Unreachable
From icmp_seq=5 Destination Host Unreachable

--- ping statistics ---
5 packets transmitted, 0 received, +5 errors, 100% packet loss, time 4008ms
, pipe 3
Some oddities in dmesg:
[ 2733.832000] wlan0: authenticate with AP 00:10:c6:28:39:57
[ 2734.032000] wlan0: authenticate with AP 00:10:c6:28:39:57
[ 2734.216000] wlan0: Initial auth_alg=0
[ 2734.216000] wlan0: authenticate with AP 00:10:c6:28:39:57
[ 2734.416000] wlan0: authenticate with AP 00:10:c6:28:39:57
[ 2734.616000] wlan0: authenticate with AP 00:10:c6:28:39:57
[ 2734.816000] wlan0: authentication with AP 00:10:c6:28:39:57 timed out
I should point out thereīs no WEP key on the network. Also, Iīm using a Ipex-Asus L8400, and not my new Toshiba L30 as the hostname suggests, just in case thatīs relevant.
Old 09-29-2007, 03:50 AM   #2
LQ Newbie
Registered: Dec 2006
Location: Somwhere
Distribution: Ubuntu Linux 8.10 Intrepid Ibex
Posts: 15

Original Poster
Rep: Reputation: 0
I followed the instructions on this thread (which I spotted in the similar threads pane) and it worked! I am, in fact posting this over the wlan.


dlink, dwlg122, feisty fawn, ubuntu, wireless

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off

Similar Threads
Thread Thread Starter Forum Replies Last Post
how to install rt73 driver for dwl-g122 rev. c1 in ubuntu dissident_goodchild Ubuntu 1 08-25-2007 01:53 PM
trying to install DWL-G122 adapter on Ubuntu 6.06 and I cannot get it to run dyara Linux - Newbie 13 02-07-2007 04:26 PM
Success using WEP with DWL-G122 on Debian and Ubuntu joespam Linux - Wireless Networking 1 12-13-2006 03:04 PM
D-Link DWL-G122 A1 on Ubuntu karjaneth Linux - Newbie 1 03-02-2006 03:07 PM > Forums > Linux Forums > Linux - Hardware

All times are GMT -5. The time now is 12:46 PM.

Main Menu
Write for LQ is looking for people interested in writing Editorials, Articles, Reviews, and more. If you'd like to contribute content, let us know.
Main Menu
RSS1  Latest Threads
RSS1  LQ News
Twitter: @linuxquestions
Facebook: linuxquestions Google+: linuxquestions
Open Source Consulting | Domain Registration