Dell Model SE177FP flat panel monitor won't install.
My operating system is Linux Fedora 5. It uses a Red Hat nash version 5.0.32 kernel. When the system is booted up the screen works and shows the boot progress until it reaches "Starting udev" at which point the screen goes blank and then displays: "Cannot display this video mode optional resolution 1280 X 1024 60 Hz."
I installed the flat panel monitor on my Windows XP operating system. The screen resolution for this automatic set up was 800 X 600. The CRT monitor for the Fedora operating system also self installs at a resolution of 800 X 600. My video card is an Intel Corp 82810E DC-133CGC [chipset graphics controller].
I loaded Fedora 5 from a distribution disk. I have never updated it because I only have dialup internet and it would take forever.
The screen message from the Dell monitor means that the monitor cannot synchronize with the signal that it is receiving from the computer. Either the signal is too high or too low for the monitor to use. The recommended mode is 1280 X 1024. THis is also the optimum preset resolution.
What must I do to get the flat panel monitor to install?
J.W. asked for the contents of the /etc/X11/xorg.conf file.
The following is the content of the monitor section:
Section "Monitor"
### Comment all HorizSync and VertSync values to use DDC:
### Comment all HorizSync and VertSync values to use DDC:
" Identifier "Monitor0"
" VendorName "Monitor Vendor"
" ModelName "AOC SPECTRUM 5Vlr & 5VlrA"
### Comment all HorizSync and VortSync values to use DDC:
" HorizSync 30.0 - 66.0
" VertRefresh 50.0 - 100.0
" Option" "dpms"
EndSection
Section "Device"
" Identifier "Videocard0"
" Driver "i810"
" VendorName "Videocard vendor"
" BoardName "Intel Corporation 82810E DC-133 CGC [Chipset Graphics Controller]"
EndSection
Section "Screen"
" Identifier "Screen0"
" Device "Videocard0"
" Monitor "Monitor0"
" DefaultDepth 24
" SubSection "Display"
" " Viewport 0 0
" " Depth 16
" " Modes "800x600" "640x480
" EndSubSection
" SubSection "Display"
" " Viewport 0 0
" " Depth 24
" " Modes "800x600" "640x480"
" EndSebSection
EndSection
Section "DRI"
" Group 0
" Mode 0666
EndSection
Last edited by richardpfeff; 01-16-2007 at 06:28 PM.
|