I have a Compaq Storage RAID Array RA4100 with FC controller installed on a "clone" computer with Linux RH 8.0.

The FC controller in my computer is recognized, and the cpqfc.o module is loaded.

The RA4100 was not equipped with disks and/or hot swap trays (only the dummies are installed).
I have two WD 9.1Gb SE Ultra FW SCSI-3 disks with a 80-pin SCA interface (WDE9100-0008A6).
One of those disks I have "temporarily" installed in the RA4100, and I am sure that the connector is properly attached.

The output of the cpqfc module is the following:

scsi_register allocating 3788 bytes for FC HBA
ioremap'd Membase: f09c3000
HBA Tachyon RevId 1.2
Allocating 119808 for 576 Exchanges @ d4a00000
Allocating 112904 for LinkQ @ d4980000 (576 elements)
Allocating 104456 for TachSEST for 512 Exchanges
cpqfcTS: writing IMQ BASE 14C80000h PI 14C84000h
cpqfcTS: SEST d49e0000(virt): Wrote base 149E0000h @ f09c3140
cpqfcTS: New FC port 000001h WWN: 500508B100040FD0 SCSI Chan/Trgt 0/0
scsi0 : Compaq FibreChannel HBA Tachyon TS HPFC-5166A/1.2: WWN
500508B2001339C0
on PCI bus 0 device 0xa0fc irq 9 IObaseL 0xa400, MEMBASE 0xe1800000
PCI bus width 32 bits, bus speed 33 MHz
FCP-SCSI Driver v2.1.2
GBIC detected: Short-wave. LPSM 0h Monitor
scsi: unknown type 12
Vendor: COMPAQ Model: ARRAY CONTROLLER Rev: 2.54
Type: Unknown ANSI SCSI revision: 02
resize_dma_pool: unknown device type 12

As you can see there is not a disk "recognized".
Is there something I still need to do, or do I need different disks.

Can anyone help me please?

Thanks,
Michael