LinuxQuestions.org

LinuxQuestions.org (/questions/)
-   Linux - General (https://www.linuxquestions.org/questions/linux-general-1/)
-   -   penguin logo during bootup? (https://www.linuxquestions.org/questions/linux-general-1/penguin-logo-during-bootup-166434/)

debuser 04-05-2004 09:38 AM

penguin logo during bootup?
 
During bootup, you see a small penguin logo on the top left side of the screen. I kind of like it. I think it is because of of bramebuffers, i am able to see it during bootup.
A few months ago I compiled my own 2.6 kernel and it worked out pretty good. I only have one complaint. Where did my penguin logo go during bootup? Is there something I need to do in my lilo.conf to enable it back?

TIA

XavierP 04-05-2004 09:42 AM

Sounds like you didn't enable the framebuffer when you recompiled the kernel. You are going to have to re-recompile to include framebuffer.

aaa 04-05-2004 09:44 AM

Assuming you enabled framebuffer in the kernel properly...:
add the 'vga=769' or similar to the lilo.conf:
#before
image=/boot/vmlinuz
label=linux
append="root=/dev/hda1"

#after
image=/boot/vmlinuz
label=linux
append="root=/dev/hda1 vga=769"

Run lilo to apply

debuser 04-05-2004 10:11 AM

Here is a part of my lilo.conf

image=/vmlinuz
label=Linux
read-only
alias=1

I think I did enable framebuffer in my kernel. As can be seen, I don't have the append line. I will try adding the append line and reboot to see if I get the logo. Can only do it, when i am in front of my computer as i wont be able to see the bootup remotely. I had another question regarding bootup, should I start another thread?

Thanks again.

XavierP 04-05-2004 10:14 AM

No - add it to this one as it's likely to be part of the same problem. It'll be more useful to another user if they have the same problem(s) - they can see the steps you have taken to resolve it.

debuser 04-05-2004 10:24 AM

Ok, So my other question is regarding apache during bootup.
My apache startup requires me to give it a passphrase(for ssl).
Is there a way to automate this so that I dont have to type this.
Mainly because, I cant be at the console when i am rebooting
remotely.. or is there a way to get the console remotely?


All times are GMT -5. The time now is 10:51 PM.