howto half/full duplex eth0
How do you check if eth0 is set to half/full duplex.
How do you set eth0 to half/full duplex. Thanks Jim |
I should have Googled It, The correct command is .
My eth0 shows status below. Jim # /sbin/ethtool eth0 Settings for eth0: Supported ports: [ TP MII ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full Supports auto-negotiation: Yes Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full Advertised auto-negotiation: Yes Speed: 100Mb/s Duplex: Full Port: MII PHYAD: 24 Transceiver: internal Auto-negotiation: on Current message level: 0x00000001 (1) Link detected: yes |
Big Help
Thanks.
Did this help big time. |
All times are GMT -5. The time now is 04:51 PM. |