Firewire usb combo pci card trouble

slacard · 03-29-2005, 10:57 PM

I recently installed a combo fw & usb pci card. I have several linux distros-mostly I run kernel 2.6.X. The card is recognized during boot but in FC3 I don't get a desktop device anymore even when I plug into the old (motherboard usb 1.1) Fedora used to auto mount the drive or camera. In mepis or knoppix I can still access either usb device I insert in either the new or older usb ports.

Here is the results of
lspci -v
0000:00:00.0 Host bridge: VIA Technologies, Inc. VT8363/8365 [KT133/KM133] (rev 03)
Flags: bus master, medium devsel, latency 8
Memory at d8000000 (32-bit, prefetchable) [size=64M]
Capabilities: <available only to root>

0000:00:01.0 PCI bridge: VIA Technologies, Inc. VT8363/8365 [KT133/KM133 AGP] (prog-if 00 [Normal decode])
Flags: bus master, 66MHz, medium devsel, latency 0
Bus: primary=00, secondary=01, subordinate=01, sec-latency=0
Memory behind bridge: dc000000-ddffffff
Prefetchable memory behind bridge: d0000000-d7ffffff
Capabilities: <available only to root>

0000:00:07.0 ISA bridge: VIA Technologies, Inc. VT82C686 [Apollo Super South] (rev 40)
Subsystem: VIA Technologies, Inc. VT82C686/A PCI to ISA Bridge
Flags: bus master, stepping, medium devsel, latency 0
Capabilities: <available only to root>

0000:00:07.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06) (prog-if 8a [Master SecP PriP])
Subsystem: VIA Technologies, Inc. VT82C586/B/VT82C686/A/B/VT8233/A/C/VT8235 PIPC Bus Master IDE
Flags: bus master, medium devsel, latency 32
I/O ports at 9000 [size=16]
Capabilities: <available only to root>

0000:00:07.2 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 1a) (prog-if 00 [UHCI])
Subsystem: VIA Technologies, Inc. (Wrong ID) USB Controller
Flags: bus master, medium devsel, latency 32, IRQ 10
I/O ports at 9400 [size=32]
Capabilities: <available only to root>

0000:00:07.3 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 1a) (prog-if 00 [UHCI])
Subsystem: VIA Technologies, Inc. (Wrong ID) USB Controller
Flags: bus master, medium devsel, latency 32, IRQ 10
I/O ports at 9800 [size=32]
Capabilities: <available only to root>

0000:00:07.4 Bridge: VIA Technologies, Inc. VT82C686 [Apollo Super ACPI] (rev 40)
Subsystem: VIA Technologies, Inc. VT82C686 [Apollo Super ACPI]
Flags: medium devsel, IRQ 11
Capabilities: <available only to root>

0000:00:07.5 Multimedia audio controller: VIA Technologies, Inc. VT82C686 AC97 Audio Controller (rev 50)
Subsystem: VIA Technologies, Inc. Onboard Audio on EP7KXA
Flags: medium devsel, IRQ 10
I/O ports at 9c00 [size=256]
I/O ports at a000 [size=4]
I/O ports at a400 [size=4]
Capabilities: <available only to root>

0000:00:0b.0 Unknown mass storage controller: Promise Technology, Inc. PDC20268 (Ultra100 TX2) (rev 02) (prog-if 85)
Subsystem: Promise Technology, Inc. Ultra100TX2
Flags: bus master, 66MHz, slow devsel, latency 32, IRQ 10
I/O ports at ac00 [size=8]
I/O ports at b000 [size=4]
I/O ports at b400 [size=8]
I/O ports at b800 [size=4]
I/O ports at bc00 [size=16]
Memory at df000000 (32-bit, non-prefetchable) [size=16K]
Capabilities: <available only to root>

0000:00:0e.0 USB Controller: ALi Corporation USB 1.1 Controller (rev 03) (prog-if 10 [OHCI])
Subsystem: ALi Corporation: Unknown device 5272
Flags: bus master, 66MHz, medium devsel, latency 32, IRQ 10
Memory at df004000 (32-bit, non-prefetchable) [size=4K]
Capabilities: <available only to root>

0000:00:0e.1 USB Controller: ALi Corporation USB 1.1 Controller (rev 03) (prog-if 10 [OHCI])
Subsystem: ALi Corporation: Unknown device 5272
Flags: bus master, 66MHz, medium devsel, latency 32, IRQ 10
Memory at df005000 (32-bit, non-prefetchable) [size=4K]
Capabilities: <available only to root>

0000:00:0e.2 USB Controller: ALi Corporation USB 1.1 Controller (rev 03) (prog-if 10 [OHCI])
Subsystem: ALi Corporation: Unknown device 5272
Flags: bus master, 66MHz, medium devsel, latency 32, IRQ 10
Memory at df006000 (32-bit, non-prefetchable) [size=4K]
Capabilities: <available only to root>

0000:00:0e.3 USB Controller: ALi Corporation USB 2.0 Controller (rev 01) (prog-if 20 [EHCI])
Subsystem: ALi Corporation: Unknown device 5272
Flags: bus master, 66MHz, medium devsel, latency 32, IRQ 11
Memory at df007000 (32-bit, non-prefetchable) [size=256]
Capabilities: <available only to root>

0000:00:0e.4 FireWire (IEEE 1394): ALi Corporation M5253 P1394 OHCI 1.1 Controller (prog-if 10 [OHCI])
Subsystem: ALi Corporation M5253 P1394 OHCI 1.1 Controller
Flags: bus master, 66MHz, medium devsel, latency 32, IRQ 10
Memory at df008000 (32-bit, non-prefetchable) [size=2K]
Capabilities: <available only to root>

0000:00:0f.0 SCSI storage controller: Advanced System Products, Inc ABP940-U / ABP960-U (rev 03)
Subsystem: Advanced System Products, Inc ASC1300 SCSI Adapter
Flags: bus master, medium devsel, latency 32, IRQ 11
I/O ports at c000 [size=256]
Memory at df009000 (32-bit, non-prefetchable) [size=256]

0000:01:00.0 VGA compatible controller: nVidia Corporation NV18 [GeForce4 MX 440 AGP 8x] (rev a2) (prog-if 00 [VGA])
Subsystem: Asustek Computer, Inc.: Unknown device 80bb
Flags: bus master, VGA palette snoop, 66MHz, medium devsel, latency 248, IRQ 5
Memory at dc000000 (32-bit, non-prefetchable) [size=16M]
Memory at d0000000 (32-bit, prefetchable) [size=128M]
Capabilities: <available only to root>

What do I need to do to get auto mounting back again? Thanks!