Yes there was a step I left out, my apologize. After adjusting the lilo.conf you must follow the steps below.
The steps are:
Here's the fix
After almost giving up on Fedora 5, I finally got the fix to this problem.
The suspend signature on swap error, "Trying to resume from LABEL=SWAP-hdd3. No suspend signature on swap, not resuming", can be ignored. It gives this error because when the volumes are activated (look at the output previous to this error), it resumes the swap partition in that step. Therefore, it's trying to resume something that isn't suspended.
The error that causes all the trouble is "mount: could not find filesystem '/dev/root'". Appartently, in the init script within initrd-2.6.15-1.2054_FC5.img, the command 'mount /sysroot' is trying to mount /dev/root to /sysroot. Fedora 5 does not use /dev/root like in the previous versions of Fedora. Instead, it uses '/dev/VolGroup00/LogVol00' or '/dev/hda1' (or whereever '/' is located) to mount to /sysroot. For some reason, when init calls 'mount /sysroot', it's trying to mount /dev/root to /sysroot, instead of /dev/VolGroup00/LogVol00 to /sysroot. This messes up everything after this step in the init process. When it does a switchroot at the end, it fails. After killing init, it causes the kernel panic.
Here's the fix:
1) Boot with the rescue CD
2) Type 'chroot /mnt/sysimage' (wherever it mounts the Fedora 5 partition)
3) 'cd /boot'
4) 'mkdir newinit'
5) 'cd newinit'
6) 'gunzip -c ../initrd-2.6.15-1.2054_FC5.img | cpio -idmv'
7) 'vi init'
8) Find 'mount /sysroot' (near the end of the file)
9) Delete or comment this out
10) Replace with 'mount -o defaults --ro -t ext3 /dev/VolGroup00/LogVol00 /sysroot' where /dev/VolGroup00/LogVol00 is the mount point for /
11) ':wq' out of vi
12) 'find . | cpio --quiet -c -o >../newinitrd'
13) 'cd ..' - you are now in /boot
14) 'mv initrd-2.6.15-1.2054_FC5.img initrd-2.6.15-1.2054_FC5.bak' - backup current initrd img file (just in case)
15) 'gzip -9 < newinitrd > initrd-2.6.15-1.2054_FC5.img'
16) Reboot the computer without the CD
* Steps 4-6,12,13,15 were taken from another site, but I couldn't post the URL. I'll try in my next post.
This should fix it. I'm glad I can finally run Fedora 5 on my box.
MarkCole, I'm not sure if you were experiencing the exact same problems I was with mounting root. However, I hope this helps anyone else experiencing the same problems I had.
Andy
Pulled from this thread
http://www.linuxquestions.org/questi...+after+install