RAID 1 Degraded Array
I have recently setup a RAID 1 Array, and have found that it is degraded/faulty not sure what this means exactly. What I want to know is how can I get it to be active and sync'ed. here are the details about the array.
cat /proc/mdstat Code:
Personalities : [raid1] Code:
/dev/md0: I only noticed this because I keep getting an email once a day or so about it happening here is the email that is sent. Code:
Subject: DegradedArray event on /dev/md1:debian |
well essnetially the second disk on both md0 and md1 is apparently shagged... as you're just on a mirror i would suggest that *IF* you have faith in the hardware, to add the device again using mdadm and let it remirror itself.
|
A better reference is the Software Raid HowTo: http://tldp.net/HOWTO/html_single/Software-RAID-HOWTO/
Your question is answered at the end of the “6.3 Simulating a drive failure” section: http://tldp.net/HOWTO/html_single/So...D-HOWTO/#ss6.3 The mdadm manpage has lots of good info, too. |
All times are GMT -5. The time now is 12:08 AM. |