hardware raid problem

SkullGirl · 08-04-2003, 12:35 PM

Hi you all.

I have a second-hand HP Netserver LH3: PIII 500, 128MB registered PC100, 1x80 GB IDE (hda), 1xCDROM (hdb), and 4x9'1 GB SCSI configured as a RAID5 array. SCSI controller is SYM53C895, onboard

I installed Woody (kernel 2.4.18) in hda, recompiled kernel with SCSI support, SCSI disk support, and SYM53C8XX support.. At boot time:
1.- BIOS: SYM found, + 1 logical drive found
2.- Debian: SYM found, but nothing about the array.

Can anybody help me? Thanks....

SkullGirl

MartBrooks · 08-04-2003, 12:47 PM

What does "dmesg" show about the controller?

SkullGirl · 08-04-2003, 04:48 PM

dmesg:

SCSI subsystem driver Revision: 1.00
sym0: <895> rev 0x1 on pci bus 1 device 7 function 0 irq 10
sym0: Symbios NVRAM, ID 7, Fast-40, LVD, parity checking
sym0: open drain IRQ line driver, using on-chip SRAM
sym0: using LOAD/STORE-based firmware.
sym0: SCSI BUS has been reset.
scsi0 : sym-2.1.17a
i2o_scsi.c: Version 0.0.1
chain_pool: 0 bytes @ c120a5a0
(512 byte buffers X 4 can_queue X 0 i2o controllers)