I installed and ran
ndiswrapper. I downloaded the WPCG54S ver 1.0 NT drivers and applied them using
ndiswrapper. It shows
Hardware present:yes. I can assign it to a WAP that has a WEP key or no WEP key and I disable the eth0 Wired adapter. For some reason, I cant resolve an IP. Furthermore, if I scan for wLAN's with my wifi radar and wardriving programs I get nothing. I have pasted the relevant info from
lspci -v below. I am running Ubuntu 6.10 on an inspiron notebook with 512MB RAM and a P4 Mobile. I would appreciate any help as I have been banging my head against this problem for a while now with little progress. Thanks.
02:01.0 Ethernet controller: Broadcom Corporation BCM4401 100Base-T (rev 01)
Subsystem: Dell Unknown device 015f
Flags: bus master, fast devsel, latency 32, IRQ 177
Memory at faffe000 (32-bit, non-prefetchable) [size=8K]
Capabilities: <access denied>
02:04.0 CardBus bridge: Texas Instruments PCI4510 PC card Cardbus Controller (rev 02)
Subsystem: Dell Unknown device 015f
Flags: bus master, medium devsel, latency 168, IRQ 169
Memory at f8000000 (32-bit, non-prefetchable) [size=4K]
Bus: primary=02, secondary=03, subordinate=06, sec-latency=176
Memory window 0: 30000000-31fff000 (prefetchable)
Memory window 1: f6000000-f7fff000
I/O window 0: 0000d000-0000d0ff
I/O window 1: 0000d400-0000d4ff
16-bit legacy interface ports at 0001
03:00.0 Network controller: Broadcom Corporation BCM4306 802.11b/g Wireless LAN Controller (rev 03)
Subsystem: Linksys WPC54G
Flags: bus master, fast devsel, latency 64, IRQ 169
Memory at f6000000 (32-bit, non-prefetchable) [size=8K]
Capabilities: <access denied>
