Suse/NovellThis Forum is for the discussion of Suse Linux.
Welcome to LinuxQuestions.org, a friendly and active Linux Community.
You are currently viewing LQ as a guest. By joining our community you will have the ability to post topics, receive our newsletter, use the advanced search, subscribe to threads and access many other special features. Registration is quick, simple and absolutely free. Join our community today!
Note that registered members see fewer ads, and ContentLink is completely disabled once you log in.
If you have any problems with the registration process or your account login, please contact us. If you need to reset your password, click here.
Having a problem logging in? Please visit this page to clear all LQ-related cookies.
Introduction to Linux - A Hands on Guide
This guide was created as an overview of the Linux Operating System, geared toward new users as an exploration tour and getting started guide, with exercises at the end of each chapter.
For more advanced trainees it can be a desktop reference, and a collection of the base knowledge needed to proceed with system and network administration. This book contains many real life examples derived from the author's experience as a Linux system and network administrator, trainer and consultant. They hope these examples will help you to get a better understanding of the Linux system and that you feel encouraged to try out things on your own.
Click Here to receive this Complete Guide absolutely free.
I'm running SLES 10 SP1. I have a mailserver with 1 drive in it currently. The other day my drive crash and I had to reinstall and restore my information. 4 days later, I'm back up. I don't want to do that again.
I have a choice between using my BIOS raid on my Asus motherboard or going with LVM in Yast. I'd prefer to go with LVM on Yast....for various reasons.
My plan was to put 2 more SATA drives on the board and create a RAID 1 with them. I take it I need to partition both of them exactly how my current drive is partitioned, correct? Right now /dev/sda is setup as /dev/sda1 = swap and /dev/sda2 = root or /.
After I do that to the other 2 drives, I would use LVM in Yast to create my RAID array with the 2 other drives.
Then I was going to "dd" my original drive to the array.
Once done, shut down, remove my original drive, then boot off the array. Am I going to need to boot off the SLES install disk to install a bootloader after I'm all done??
Did I miss anything? I spent a long time getting my mailserver back up and running and I would hate to have to do it again. I'm in a small office and email is critical (but isn't it always?)