X and LILO DONT START
 

OK, I successfully installed Slackware 9.1 Now i have two words to say:

COMPLEATE DISASTER!!

first, i rebooted the machine. And then my BIOS checked for the boot loaded (LILO) and then on the nextline, it sais "L" and doesnt do anything. So I cant even get into windows right now. (I installed the LILO on the boot table or whatever its called, GRUB worked fine like that)

So then i put in my Rescue Disk, logged in as root, and went into /etc/X11/ and ran xf86config. Set it up MANY times to suite my hardware specs, and also the minimal REfresh rates and low resolutions and different drivers. And i cannot get X to open. It just sais a bunch of stuff then sais "Could not start X, make sure it is not already running." Please help, I really want this to work, If not i will go back to SuSE

Athlon XP 1700+
ATI Radeon 9800 pro 128MB
512MB RAM

Btw, is there Any X configureation program in Slackware similar to SuSE's SaX?

Re: X and LILO DONT START
 

what is your monitor's h sync and v sync? these seems to be one of the most important details we must provide during xf86config

Mine is 30-70 & 50-160

for ur lilo problem is that put ur slackware 9.1 bootable cd then don't
boot from the cd boot to ur linux partition
boot: root=/dev/hda(no.) noinitrd ro
get into root type lilo
and for x problem is you have correctly specify ur horizontal and vertical synchronisation.
run xf86config again
do it let see what happens?
--------------------------------------------------------------------------------------------
#init vladibadirtaldo
#^Q^Q^Q

My h sync is 31-96, my v sync is 55-160. I entered these.