my new lan card

ahmed gamal · 07-02-2008, 04:17 PM

elslamo alikom all
i have installed Slackware 12.1
then i make netconfig and configured my network
but the net didn't work
when i was using slack 10.2 or 12 it was working very good
i activated Knemo it gives a cross on the network figure
this is what i did

Quote:

lspci
00:0b.0 Ethernet controller: VIA Technologies, Inc. VT6105 [Rhine-III] (rev 86)

Quote:

root@host:~# ping 192.168.1.1
PING 192.168.1.1 (192.168.1.1) 56(84) bytes of data.
From 192.168.1.20 icmp_seq=1 Destination Host Unreachable
From 192.168.1.20 icmp_seq=2 Destination Host Unreachable
From 192.168.1.20 icmp_seq=3 Destination Host Unreachable
From 192.168.1.20 icmp_seq=4 Destination Host Unreachable
From 192.168.1.20 icmp_seq=5 Destination Host Unreachable
From 192.168.1.20 icmp_seq=6 Destination Host Unreachable

and it is working very good on windows
is there any comments that can help??

Cuetzpallin · 07-02-2008, 04:53 PM

Quote:

Originally Posted by ahmed gamal

elslamo alikom all
i have installed Slackware 12.1
then i make netconfig and configured my network
but the net didn't work
when i was using slack 10.2 or 12 it was working very good
i activated Knemo it gives a cross on the network figure
this is what i did

and it is working very good on windows
is there any comments that can help??

Did you make a fresh install or you upgraded from 12.0?

ahmed gamal · 07-02-2008, 06:25 PM

no i have made a fresh install

Daedra · 07-02-2008, 06:31 PM

try (as root)

modprobe via-rhine

that is the correct module, then do

lsmod

and confirm that the module was loaded.

ahmed gamal · 07-02-2008, 07:03 PM

there is something very strange
i had an old lan card called Realtech it wasn't working with kernel 2.6
now i tried it and it is working
i had made the command this is its output

Quote:

via_rhine 24968 0

onebuck · 07-02-2008, 11:49 PM

Hi,

You did run 'netconfig'?

If so then post the output of the following;

Code:

ifconfig -a
route -n