Hello all!
Using sony vaio sz2xrp; Slackware 12.1
Booted with my external IDE hard disk plugged in. Got these messages:
Quote:
Adding 1951888k swap on /dev/sda2. Priority:-1 extents:1 across:1951888k
fuse init (API version 7.9)
scsi 4:0:0:0: Direct-Access TOSHIBA MK8025GAS 0000 PQ: 0 ANSI: 0
sd 4:0:0:0: [sdb] 149750400 512-byte hardware sectors (76672 MB)
sd 4:0:0:0: [sdb] Write Protect is off
sd 4:0:0:0: [sdb] Mode Sense: 27 00 00 00
sd 4:0:0:0: [sdb] Assuming drive cache: write through
sd 4:0:0:0: [sdb] 149750400 512-byte hardware sectors (76672 MB)
sd 4:0:0:0: [sdb] Write Protect is off
sd 4:0:0:0: [sdb] Mode Sense: 27 00 00
sd 4:0:0:0: [sdb] Mode Sense: 27 00 00 00
sd 4:0:0:0: [sdb] Assuming drive cache: write through
sdb: sdb1
sdb: p1 exceeds device capacity
sd 4:0:0:0: [sdb] Attached SCSI disk
sd 4:0:0:0: Attached scsi generic sg1 type 0
usb-storage: device scan complete
attempt to access beyond end of device
sdb: rw=0, want=149757760, limit=149750400
Buffer I/O error on device sdb1, logical block 149757696
attempt to access beyond end of device
sdb: rw=0, want=149757761, limit=149750400
Buffer I/O error on device sdb1, logical block 149757697
attempt to access beyond end of device
sdb: rw=0, want=149757762, limit=149750400
Buffer I/O error on device sdb1, logical block 149757698
attempt to access beyond end of device
sdb: rw=0, want=149757763, limit=149750400
Buffer I/O error on device sdb1, logical block 149757699
|
sdb is the external hard drive.
Does this mean that the disk was not partitioned correctly? The disk is FAT32 and has only one partition.
However, it might have a few bad blocks, although as far as I know, bad blocks return different output.
Thanks.
